802.11 b/g Access Point Command Line Interface Manual
1
1
USING THE CLI
The DWL-2100AP can be accessed by Telnet. Using Microsoft Windows Operation system as example, open the Command Prompt on the computer that will be used for configuring and
managing the AP and enter telnet and IP address of DWL-2100AP in the first line. Using the default IP address as example, enter telnet 192.168.0.50 to cause the following screen to open:
Press Enter in the screen above. The following screen opens:
Type ¡admin¡ for the D-Link Access Point login username in the screen above and press Enter. The following screen opens:
To Next Page
Loading...
