D-Link DWL-2100AP - Time Display & SNTP Commands

802.11 b/g Access Point Command Line Interface Manual
21
11
TIME DISPLAY & SNTP COMMANDS
Command: Function Syntax
timeofday Displays the Current Time of Day
timeofday
Note: Need to set up SNTP/NTP server firstly
Get Command Function Syntax
get sntpserver Display SNTP/NTP Server IP Address get sntpserver
get tzonelist Display Time Zone get tzonelist
get tzone Display Time Zone Setting get tzone
get daylightsaving Display Day Light Saving Time get daylightsaving
Set Command Function Syntax
set sntpserver Set SNTP/NTP Server IP Address
set sntpserver <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set tzone Set Time Zone Setting
set tzone [0=GMT]
Note: use get tzonelist to get tzone information
set daylightsaving Set Day Light Saving Time
set daylightsaving [0:1]
Explanation: 0=disable:1=enable