D-Link DWL-2100AP - Page 22

802.11 b/g Access Point Command Line Interface Manual
20
snmp editprivatecomm Edit private communication String snmp editprivatecomm <privateCommunityString>
snmp addcomm Add Communication String
snmp addcomm <CommunityString> <ViewName> [Type]
Explanation:
CommunityString: <string>
ViewName:<string>
Type:1: Read-Only, 2: Read-Write
snmp delcomm Delete Community String snmp delcomm <CommunityString>
snmp showcomm Show Community String Table snmp showcomm
snmp addhost Add Host To Notify List
snmp addhost TrapHostIP<string> [SnmpType] [AuthType
]
<AuthString>
Explanation:
TrapHostIP: <string>
SnmpType: 1: v1 2: v2c 3: v3
AuthType: 0: v1_v2c 1: v3_noauth_nopriv 2: v3_auth_nopriv
3 v3_auth_priv>
AuthString: <string>, CommunityString for v1,v2c or UserName
for:v3
snmp delhost Delete Host From Notify List snmp delhost <TrapHostIP >
snmp showhost Show Host In Notify List snmp showhost
snmp authtrap Set Auth Trap Status snmp authtrap [enable:disable]
snmp sendtrap Send Warm Trap snmp sendtrap
snmp status Display SNMP Agent status snmp status
snmp suspend Suspend SNMP Agent snmp suspend
snmp resume Resume SNMP Agent snmp resume
snmp load_default Load SNMP Default Settings snmp load_default
snmp location Set SNMP Location snmp location
snmp showlocation Display SNMP Location snmp showlocation
get trap Display TRAP Information get trap
set trap Set Trap settings set trap state [0:1]