802.11 b/g Access Point Command Line Interface Manual
22
12
TELNET & SSH COMMANDS
TFTP Commands:
Command: Function Syntax
tftp get Get a file from TFTP Server. tftp get Filename<string>
tftp uploadtxt Upload the configuration of the device to TFTP Server. tftp uploadtxt Filename<string>
tftp srvip Setup the TFTP Server IP address. tftp srvip <xxx.xxx.xxx.xxx>
tftp update Update the file to the device. tftp update
tftp info Information about the TFTPC setting. tftp info
get telnet Display Telnet Status of current login, number of login attempts, etc. get telnet
get timeout Display Telnet Timeout in seconds get timeout
set telnet Set Telnet Access/SSL Mode to enabled or disabled
set telnet <0:1:2>
Explanation:
0=disable telnet and enable SSL
1=enable telnet and disable SSL
2=disable both telnet and SSL
set timeout
Set Telnet Timeout in seconds, 0 is never and 900 seconds is the
maximum <0-900>
set timeout <0-900>
SSH Commands
Command: Function Syntax
ssh showuser Show SSH User ssh showuser
ssh setrekey Set SSH Rekey
ssh setrekey [0-3]
Explanation:
0:10Min
1:30Min
2:60Min
3:Never
ssh loaddefault Load SSH Default Setting ssh loaddefault
ssh showalgorithm Show SSH Algorithm ssh showalgorithm
To Next Page
Loading...
