D-Link DWL-2100AP - Access Point WPA-PSK Security Configuration

802.11 b/g Access Point Command Line Interface Manual
15
set multi-authentication Set Authentication Type for Multi-SSID
set multi-authentication
[open-system:shared-key:wpa:wpa-psk:wpa2:wpa2-psk:wpa-auto:w
pa-auto-psk] [index]
set multi-wmm Set WMM Mode set multi-wmm [disable:enable]
set multi-cipher Set Cipher for Multi-SSID set multi-cipher [wep:aes:tkip:auto] [index]
set multi-encryption Set Encryption Mode for Multi-SSID set multi-encryption [disable:enable] [index]
set multi-keyentrymethod Select Encryption Key Entry Method for Multi-SSID set multi-keyentrymethod [hexadecimal:asciitext] [index]
set multi-key Set Encryption Key for Multi-SSID set multi-key default [key index] [multi-ssid index]
set multi-passphrase Set PassPhrase for Multi-SSID set multi-passphrase [index] <passphrase>
Routing Commands (Spaning Tree Protocol)
Set Command: Function Syntax
rstp setstate Enable or Disable Spanning Tree
Protocol supporting in VLAN /
Multi-SSID
rstp setstate [0:1]
Explanation: 0=disable:1=enable
rstp getstate Show Spanning Tree State rstp getstate
rstp setstp Modify Spanning Tree Settings
rstp setstp maxage [6 - 40]
rstp setstp hellotime [1-10]
rstp setstp forwarddely [4-30]
rstp setstp priority [0-61440], (note: 0 is the highest)
rstp setstp version [1:2], (note: 1 is stp and 2 is rstp)
rstp setstp txholdcount [1-10]
rstp setstp fbpdu[0 :1], (note: 0 is disable and 1 is enable)
rstp getstp Show Spanning Tree Settings rstp getstp
rstp setport Modify STP Port Settings
, includes cost , priority, edge, p2p and state
parameters
rstp setport
rstp getport Show STP Port Settings rstp getport
rstp setdefault Set Factory Default rstp setdefault