D-Link DWL-2100AP - AP Client WEP Security Configuration

802.11 b/g Access Point Command Line Interface Manual
27
D-Link Access Point wlan1 -> set authentication wpa
Authentication Type: WPA
D-Link Access Point wlan1 -> set encryption enable
Encryption: Enabled
D-Link Access Point wlan1 -> set cipher auto
Cipher selection: AUTO
D-Link Access Point wlan1 -> set radiusname 192.168.0.99
RADIUS server name: 192.168.0.99
D-Link Access Point wlan1 -> set radiussecret
Old RADIUS shared secret->
New RADIUS shared secret-> **********
Type RADIUS secret again to confirm-> **********
RADIUS shared secret confirmed
D-Link Access Point wlan0 -> set keysource server
Key Source: server
Once the user has set up the AP to their satisfaction, the device must be rebooted to save settings.
D-Link Access Point wlan1 -> reboot