D-Link DWL-2600AP

Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 78
January 2015
Section 6 - Conguring SNMPv3
Note: After you congure the SNMPv3 Users settings, you must click Apply to apply the changes
and to save the settings.
Conguring SNMPv3 Targets
SNMPv3 Targets send “inform” messages to the SNMP manager. Each target is identied by a target name and
associated with target IP address, UDP port, and SNMP user name.
Figure 43 - SNMPv3 Targets Conguration
Field Description
IPv4/IPv6 Address Enter the IP address of the remote SNMP manager to receive the target.
Port Enter the UDP port to use for sending SNMP targets.
Users Select the name of the SNMP user to associate with the target. To congure SNMP users,
see “Conguring SNMPv3 Users” on page 77.
SNMPv3 Targets This eld shows the SNMPv3 Targets on the UAP. To remove a target, select it and click
Remove.
Table 46 - SNMPv3 Targets
Note: After you congure the SNMPv3 Target settings, you must click Apply to apply the changes
and to save the settings.