1.8.5 Load Balancing
The Wireless Switch performs load balancing on a per radio basis by tracking the
wireless bandwidth utilization. The maximum bandwidth utilization is configured in the
Radio tab of the Basic Setup. If the utilization reaches the configured threshold then new
client associations are rejected. The default bandwidth utilization threshold is 60%. The
WLAN Utilization may be monitored in the Radio Details tab of Monitoring Æ Access
Points Æ Managed Access Points.
1.9 Switch and AP Cleanup
You will not need any of the settings you configured in this scenario for the other three
scenarios, so it is a good idea to reset the switch and the APs to the factory defaults.
To reset the switch configuration, click the Tools menu and select Reset Configuration.
To reset the AP configuration, you will need to telnet into the AP CLI and use the
“factory-reset” command. As mentioned earlier, you can place the AP into “debug”
mode from the switch if the AP is currently managed to gain access to the UI.
To Next Page
Loading...
Need help?
General
