2.2 Configuring WLAN Settings
All of the features you configure in this section are within the WLAN tab on the D-LINK
Wireless Switch.
Use the following steps to configure the Wireless Switch and the APs.
1. On the Global tab of the Administration Æ Basic Setup page, make sure the switch
IP address is the Loopback interface address (192.168.10.254), the country code is
correct, and that the WLAN Switch Operational Status is Enabled.
2. Click Next to go to the Discovery tab on the Basic Setup page.
3. Add VLAN 20 and VLAN 30 to the L2/VLAN Discovery list (to allow automatic
discovery of the APs connected to ports on VLANs 20 and 30), then click Submit.
To Next Page
Loading...
Need help?
General
