D-Link Eagle Pro AI AX1500 E15 - Page 36

33D-Link E15 User Manual
Section 3 - Conguration
IPv6 - Auto conguration (SLAAC/DHCPv6)
My Internet Connection
is
Select Auto conguration (SLAAC/DHCPv6) to have the E15
automatically receive an IPv6 address from the uplink router.
Obtain a DNS server
address automatically
You can obtain IPv6 DNS server information automatically,
or configure DNS servers manually by selecting Use the
following DNS address.
Primary DNS For manual settings, enter the primary IPv6 DNS server address.
Secondary DNS For manual settings, enter the secondary IPv6 DNS server
address. This is optional but will provide backup if the primary
server fails.
IPv6 - Static IPv6
My Internet Connection
is
Select Static IPv6 to manually assign an IP address to the E15.
IPv6 Address Enter the IPv6 address that you want to assign to the extender.
This address should be outside of the uplink router’s DHCP
address pool.
Subnet Prex Length Enter the length of the IPv6 subnet prex for identifying the
IPv6 subnetwork (valid range: 1~128).
Default Gateway Enter the default gateway.
Primary DNS Enter the primary IPv6 DNS server address.
Secondary DNS Enter the secondary IPv6 DNS server address. This is optional
but will provide backup if the primary server fails.
IPv6 - Local Connectivity Only
My Internet Connection
is
Select Local Connectivity Only to set an IPv6 address only
for the local network.
LAN IPv6 Link-Local
Address
The link-local address of the E15 is used only within the local
network specic to a physical interface.