D-Link Eagle Pro AI AX1500 E15 - Network Settings (IPv4;IPv6)

32D-Link E15 User Manual
Section 3 - Conguration
Network Settings
This page lets you congure the network settings for the E15. To access this page, click Settings > Network.
Click Save to apply the settings and a reboot may be required.
Management Link You can change the URL of the device by editing the text in
the box. If you You can replace E15-xxxx with a name of your
choice for “http://E15-xxxx.local./” (where “xxxx” represents the
last 4 digits of the MAC address). However, you will need to
enter the modied URL in the address bar of your web browser
to access the conguration utility.
Advanced Settings
The Advanced Settings section of the Network Settings page allows you to
congure both IPv4 and IPv6 settings for communicating with the E15.
IPv4
My Internet
Connection is
Here you can select the method of assigning an IP address to
the E15: Dynamic IP or Static IP addressing mechanism. If
you select Dynamic IP, the options below will not be available.
IP Address Assign an IPv4 address. This address should be outside of the
uplink router’s DHCP address pool.
Subnet Mask Enter the subnet mask. It is used to determine the subnet of
an IP address.
Gateway Address
Enter the gateway address. This is usually the IP address of
the uplink router.
Primary DNS Enter the address of the primary DNS server. It is the address
of the server used to resolve hostnames to IP addresses.
Secondary DNS Enter the address of the secondary DNS server. This is optional
but will provide backup if the primary server fails.