D-Link Eagle Pro AI AX1500 E15 - Page 54

51D-Link E15 User Manual
Section 6 - Troubleshooting
• Access the web management interface. Open your web browser and enter the address of your extender:
http://XXXX.devicesetup.net/ (XXXX represents the last 4 digits of the MAC address) in the address bar. This should open the
login page for your web management. If the E15 is connected to an uplink router, you can try accessing the web interface using
a client IP address assigned from the uplink router. On the other hand, if the E15 is not connected to an uplink router, you can try
accessing the web interface using the default IP address http://192.168.0.50.
• If you still cannot access the conguration, unplug the extender from the power outlet for at least 10 seconds and plug it back
in. Wait about 30 seconds and try accessing the conguration. If you have multiple computers, try connecting using a dierent
computer.
2. What can I do if I forgot my password?
If you forgot your password, you must reset your extender. Unfortunately this process will change all your settings back to the
factory defaults.
To reset the extender, locate the reset button (hole) on the side panel of the unit. When the extender is powered on, use a paperclip
to press the button and then release it (the Status LED should turn red). The extender will go through its reboot process (the LED
remains red). Wait about 30 seconds to access the extender and you will be required to go through the initial setup again. Refer to
“Wireless Setup Wizard” on page 16.