xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config mld_snooping querier
between group-specific query messages. This interval may be reduced to lower the
amount of time it takes a router to detect the loss of a last listener group. The user may
set this interval between 1 and 25 seconds with a default setting of 1 second.
state [enable | disable] – Enabling the querier state will set the Switch as a MLD
querier and disabling it will set it as a Non-querier. The default setting is enabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the MLD snooping querier:
DGS-3400:4#config mld_snooping querier vlan default query_interval 125 state enable
Command : config mld_snooping querier vlan default query_interval 125 state enable
Success.
DGS-3400:4#
NOTE: The robustness variable of the MLD snooping querier is used in creating the following
MLD message intervals:
Group Listener Interval – This is the amount of time that must pass before a multicast router
decides that there are no more listeners present of a group on a network. Calculated as
(robustness variable * query interval ) + (1 * query interval).
Querier Present Interval - This is the amount of time that must pass before a multicast router
decides that there are no other querier devices present. Calculated as (robustness variable *
query interval) + (0.5 * query response interval).
Last Listener Query Count – This is the amount of group-specific queries sent before the
router assumes there are no local listeners in this group. The default value is the value of the
robustness variable.
show mld_snooping
Purpose Used to display the current status of the MLD snooping function on the Switch.
Syntax
show mld_snooping {vlan<vlan_name 32}
Description This command allows you to display the current status of the MLD snooping
function on the Switch.
Parameters
vlan <vlan_name 32> − The name of the VLAN for which to view the MLD
snooping configurations.
If no parameter is specified, the Switch will display all current MLD snooping
configurations.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the MLD snooping settings
132
To Next Page
Loading...
