D-Link xStack DGS-3450 - Page 150

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config 802.1x auth_protocol
Purpose Used to configure the 802.1x authentication protocol on the
Switch.
Syntax
config 802.1x auth_protocol [local | radius_eap]
Description The config 802.1x auth_protocol command enables
configuration of the authentication protocol.
Parameters [local | radius_eap] – Specify the type of authentication protocol
desired.
Only administrator-level users can issue this command. Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DGS-3400:4#
DGS-3400:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
show acct_client
Purpose Used to display the current RADIUS accounting client.
Syntax
show acct_client
Description The show acct_client command is used to display the current
RADIUS accounting client currently configured on the Switch.
Restrictions None.
Parameters None.
Example usage:
To view the current RADIUS accounting client:
DGS-3400:4#show acct_client
Command: show acct_client
radiusAcctClientInvalidServerAddresses 0
radiusAuthServerEntry 0
radiusAccClientRequests 0
radiusAccClientMalformedResponses 0
radiusAccClientTimeouts 0
radiusAcctClient
---------------------------------------------------------------------------------------
radiusAcctClientIdentifier D-Link
---------------------------------------------------------------------------------------
radiusAccServerIndex 1
radiusAccServerAddress 10.53.13.199
radiusAccClientServerPortNumber 0
radiusAccClientRoundTripTime 0
radiusAccClientRetransmissions 0
radiusAccClientResponses 0
radiusAccClientBadAuthenticators 0
radiusAccClientPendingRequests 0
radiusAccClientUnknownTypes 0
radiusAccClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
147