D-Link xStack DGS-3450 - Page 151

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show auth_client
Purpose Used to display the current RADIUS authentication client.
Syntax
show auth_client
The show auth_client command is used to display the current
RADIUS authentication client currently configured on the Switch.
Restrictions
Description
Parameters None.
None.
Example usage:
To view the current RADIUS authentication client:
radiusAuthClientInvalidServerAddresses 0
radiusAuthServerEntry 0
radiusAuthServerAddress : 0.0.0.0
radiusAuthClientAccessAccepts 0
DGS-3400:4#show auth_client
Command: show auth_client
radiusAuthClient
----------------------------------------------------------------------------------------
radiusAuthClientIdentifier D-Link
----------------------------------------------------------------------------------------
radiusAuthServerIndex : 1
radiusAuthClientServerPortNumber 0
radiusAuthClientRoundTripTime 0
radiusAuthClientAccessRequests 0
radiusAuthClientAccessRetransmissions 0
radiusAuthClientAccessRejects 0
radiusAuthClientAccessChallenges 0
radiusAuthClientMalformedAccessResponses 0
radiusAuthClientBadAuthenticators 0
radiusAuthClientPendingRequests 0
radiusAuthClientTimeouts 0
radiusAuthClientUnknownTypes 0
radiusAuthClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show auth_diagnostics
Purpose Used to display the current authentication diagnostics.
Syntax
show auth_diagnostics {ports [<portlist> | all]}
Description The show auth_diagnostics command is used to display the
current authentication diagnostics of the Switch on a per port basis.
Parameters
ports <portlist> − Specifies a range of ports.
all – Specifies that all ports will be viewed.
Restrictions None.
Example usage:
To display the current authentication diagnostics for port 16:
148