xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
disable clipaging
Purpose
Used to disable the pausing of the console screen scrolling at the
end of each page when the show command displays more than one
screen of information.
Syntax disable clipaging
Description
This command is used to disable the pausing of the console screen
at the end of each page when the show command would display
more than one screen of information.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To disable pausing of the screen display when show command output reaches the end of the page:
DGS-3400:4#disable clipaging
Command: disable clipaging
Success.
DGS-3400:4#
enable telnet
Purpose
Used to enable communication with and management of the Switch
using the Telnet protocol.
Syntax enable telnet <tcp_port_number 1-65535>
Description
This command is used to enable the Telnet protocol on the Switch.
The user can specify the TCP or UDP port number the Switch will
use to listen for Telnet requests.
Parameters
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The “well-known” TCP port for
the Telnet protocol is 23.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable Telnet and configure port number:
DGS-3400:4#enable telnet 23
Command: enable telnet 23
Success.
DGS-3400:4#
disable telnet
Purpose
Used to disable the Telnet protocol on the Switch.
Syntax disable telnet
Description
This command is used to disable the Telnet protocol on the Switch.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
16
To Next Page
Loading...
Need help?
General