xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config serial_port
Purpose
Used to configure the serial port.
Syntax config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
Description
This command is used to configure the serial port’s baud rate and auto
logout settings.
Parameters
baud_rate [9600 | 19200 | 38400 | 115200]− The serial bit rate that will be
used to communicate with the management host. There are four options:
9600, 19200, 38400, 115200.
never − No time limit on the length of time the console can be open with
no user input.
2_minutes − The console will log out the current user if there is no user
input for 2 minutes.
5_minutes − The console will log out the current user if there is no user
input for 5 minutes.
10_minutes − The console will log out the current user if there is no user
input for 10 minutes.
15_minutes − The console will log out the current user if there is no user
input for 15 minutes.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure baud rate:
DGS-3400:4#config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Success.
DGS-3400:4#
enable clipaging
Purpose
Used to pause the scrolling of the console screen when the show
command displays more than one page.
Syntax enable clipaging
Description
This command is used when issuing the show command which
causes the console screen to rapidly scroll through several pages.
This command will cause the console to pause at the end of each
page. The default setting is enabled.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable pausing of the screen display when the show command output reaches the end of the page:
DGS-3400:4#enable clipaging
Command: enable clipaging
Success.
DGS-3400:4#
15
To Next Page
Loading...
Need help?
General