xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
To display the Switch’s information:
DGS-3400:4#show switch
Command: show switch
Device Type : DGS-3427 Gigabit Ethernet Switch
MAC Address : 00-80-C8-34-27-00
IP Address : 10.34.27.100 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.20-B13
Firmware Version : Build 1.00-B14
Hardware Version : 0A1
System Name : DGS-3427
System Location : BR5-49
System Contact : Junior Sample
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
MLD Snooping : Disabled
TELNET : Enabled (TCP 23)
WEB : Enabled (TCP 80)
RMON : Disabled
SSL status : Disabled
SSH status : Disabled
802.1x : Disabled
Jumbo Frame : Off
Clipaging : Enabled
MAC Notification : Disabled
Port Mirror : Disabled
SNTP : Disabled
HOL Prevention State : Enabled
Syslog Global State : Disabled
Single IP Management : Disabled
Dual Image : Supported
DGS-3400:4#
show serial_port
Purpose
Used to display the current serial port settings.
Syntax show serial_port
Description
This command displays the current serial port settings.
Parameters
None.
Restrictions
None
Example usage:
To display the serial port setting:
DGS-3427:4#show serial_port
Command: show serial_port
Baud Rate : 115200
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
DGS-3427:4#
14
To Next Page
Loading...
