xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
save
Purpose
Used to save changes in the Switch’s configuration to non-volatile
RAM.
Syntax save {[config <config_id 1-2> | log | all]}
Description
This command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch’s memory each time the Switch is restarted.
Parameters
config <config_id 1-2> - Specifiy to save current settings to
configuration file 1 or 2.
log - Specifiy to save current Switch log to NV-RAM.
all – Specifiy to save all configuration settings. If nothing is specified
after “save”, the Switch will save all.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DGS-3400:4#save
Command: save
Saving all configurations to NV-RAM... Done.
DGS-3400:4#
reboot
Purpose
Used to restart the Switch.
Syntax reboot
Description
This command is used to restart the Switch.
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To restart the Switch:
DGS-3400:4#reboot
Command: reboot
Are you sure want to proceed with the system reboot? (y|n)
Please wait, the switch is rebooting...
18
To Next Page
Loading...
