xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
reset
Purpose
Used to reset the Switch to the factory default settings.
Syntax reset {[config | system]}
Description
This command is used to restore the Switch’s configuration to the
default settings assigned from the factory.
Parameters
config − If the keyword ‘config’ is specified, all of the factory default
settings are restored on the Switch including the IP address, user
accounts, the switch history log and banner. The Switch will not save
or reboot.
system − If the keyword ‘system’ is specified all of the factory default
settings are restored on the Switch. The Switch will save and reboot
after the settings are changed to default. Rebooting will clear all
entries in the Forwarding Data Base.
If no parameter is specified, the Switch’s current IP address, user
accounts, the switch history log and banner are not changed. All
other parameters are restored to the factory default settings. The
Switch will not save or reboot.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-3400:4#reset config
Command: reset config
Are you sure to proceed with system reset?(y/n)
Success.
DGS-3400:4#
login
Purpose
Used to log in a user to the Switch’s console.
Syntax login
Description
This command is used to initiate the login procedure. The user will be
prompted for a Username and Password.
Parameters
None.
Restrictions
None.
Example usage:
To initiate the login procedure:
DGS-3400:4#login
Command: login
UserName:
19
To Next Page
Loading...
Need help?
General