xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show sim
information concerning the SIM group. To view a specific group, include the
commander’s MAC address of the group.
neighbor – Entering this parameter will display neighboring devices of the Switch. A
SIM neighbor is defined as a switch that is physically connected to the Switch but is
not part of the SIM group. This screen will produce the following results:
Port – Displays the physical port number of the commander switch where
the uplink to the neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor switch.
Role – Displays the role(CS, CaS, MS) of the neighbor switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To show the SIM information in detail:
DGS-3400:4#show sim
SIM Version : VER-1.61
MAC Address : 00-10-20-33-45-00
Command: show sim
Firmware Version : 1.20.B15
Device Name :
Capabilities : L2
Platform : DGS-3400 L2 Switch
SIM State : Disabled
Role State : Candidate
Discovery Interval : 30 sec
Holdtime : 100 sec
DGS-3400:4#
To show the candidate information in summary, if the candidate ID is specified:
DGS-3400:4#show sim candidates 1-2
Command: show sim candidates 1-2
ID MAC Address Platform / Hold Firmware Device Name
Capability Time Version
--- ----------------- ------------------------ ----- --------- ----------------
1 00-01-02-03-04-00 DGS-3400 L2 Switch 40 1.20-B15 The Man
2 00-55-55-00-55-00 DGS-3400 L2 Switch 140 1.20-B15 default master
Total Entries: 2
DGS-3400:4#
To show the member information in summary, if the member ID is specified:
DGS-3400:4#show sim member 1-2
Command: show sim member 1-2
ID MAC Address Platform / Hold Firmware Device Name
Capability Time Version
--- ----------------- ------------------------ ---- --------- ----------------
1 00-01-02-03-04-00 DGS-3400 L2 Switch 40 1.20-B15 The Man
2 00-55-55-00-55-00 DGS-3400 L2 Switch 140 1.20-B15 default master
Total Entries: 2
DGS-3400:4#
230
To Next Page
Loading...
