xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
To show other groups information in summary, if group is specified:
DGS-3400:4#show sim group
Command: show sim group
SIM Group Name : default
ID MAC Address Platform / Hold Firmware Device Name
Capability Time Version
--- ----------------- ------------------------ ----- --------- ----------------
*1 00-01-02-03-04-00 DGS-3400 L2 Switch 40 1.20-B15 Trinity
2 00-55-55-00-55-00 DGS-3400 L2 Switch 140 1.20-B15 default master
SIM Group Name : SIM2
ID MAC Address Platform / Hold Firmware Device Name
Capability Time Version
--- ----------------- ----------------------- ------ --------- ----------------
*1 00-01-02-03-04-00 DGS-3400 L2 Switch 40 1.20-B15 Neo
2 00-55-55-00-55-00 DGS-3400 L2 Switch 140 1.20-B15 default master
‘*’ means commander switch.
DGS-3400:4#
Example usage:
To view SIM neighbors:
DGS-3400:4#show sim neighbor
Command: show sim neighbor
Neighbor Info Table
Port MAC Address Role
------ ------------------ ---------
23 00-35-26-00-11-99 Commander
23 00-35-26-00-11-91 Member
24 00-35-26-00-11-90 Candidate
Total Entries: 3
DGS-3400:4#
reconfig
Purpose Used to connect to a member switch, through the commander
switch, using telnet.
Syntax
reconfig {member_id <value 1-32 | exit}
Description This command is used to reconnect to a member switch using telnet.
Parameters member_id <value 1-32> - Select the ID number of the member
switch the user desires to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To connect to the MS, with member ID 2, through the CS, using the command line interface:
231
To Next Page
Loading...
