D-Link xStack DGS-3450 - Page 244

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
DGS-3400 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.20-B15
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
================================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------
show greeting_message
Purpose Used to view the currently configured greeting message
configured on the Switch.
Syntax
show greeting_message
Description This command is used to view the currently configured greeting
message on the Switch.
Parameters None.
Restrictions None.
Example usage:
To view the currently configured greeting message:
DES-3400:4#show greeting_message
Command: show greeting_message
=========================================================================
DES-3400 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.B30
Copyright(C) 2004-2005 D-Link Corporation. All rights reserved.
=========================================================================
DES-3400:4#
241