xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config command prompt
Purpose Used to Configure the command prompt.
Syntax
config command_prompt [<string 16> | username | default]
Description Administrator level users can use this command to change the
command prompt.
Parameters string 16 - The command prompt can be changed by entering a
new name of no more that 16 characters.
username - The command prompt will be changed to the login
username.
default – The command prompt will reset to factory default
command prompt.
Restrictions Only administrator-level users can issue this command. Other
restrictions include:
• If the “reset/reset config” command is executed, the
modified command prompt will remain modified. However,
the “reset system” command will reset the command
prompt to the original factory banner.
Example usage
To modify the command prompt to “AtYourService”:
DGS-3400:4#config command_prompt AtYourService
Command: config command_prompt AtYourService
Success.
AtYourService:4#
242
To Next Page
Loading...
