xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
config stp mst_ports
occurs. A lower internalCost represents a quicker transmission.
priority <value 0-240> - Enter a value between 0 and 240 to set the
priority for the port interface. A higher priority will designate the interface
to forward packets first. A lower number denotes a higher priority.
Restrictions Only administrator-level users can issue this command.
Example usage:
To designate ports 1 to 2 on, with instance ID 0, to have an auto internalCost and a priority of 0:
DGS-3400:4#config stp mst_ports 1-2 instance_id 0 internalCost auto priority 0
Command: config stp mst_ports 1-2 instance_id 0 internalCost auto priority 0
Success.
DGS-3400:4#
show stp
Purpose Used to display the Switch’s current STP configuration.
Syntax
show stp
Description This command displays the Switch’s current STP configuration.
Parameters None.
Restrictions None.
Example usage:
To display the status of STP on the Switch:
Status 1: STP enabled with STP compatible version
DGS-3400:4#show stp
Command: show stp
STP Status : Enabled
STP Version : STP Compatible
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Age : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
Loopback Detection : Enabled
LBD Recover Time : 60
DGS-3400:4#
Status 2 : STP enabled for RSTP
76
To Next Page
Loading...
