D-Link xStack DGS-3450 - Page 80

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#show stp
Command: show stp
STP Status : Enabled
STP Version : RSTP
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Age : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
Loopback Detection : Enabled
LBD Recover Time : 60
DGS-3400:4#
Status 3 : STP enabled for MSTP
DGS-3400:4#show stp
Command: show stp
STP Bridge Global Settings
---------------------------
STP Status : Enabled
STP Version : MSTP
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Hops : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
LoopBack Detection : Enabled
LBD Recover Time : 60
DGS-3400:4#
show stp ports
Purpose Used to display the Switch’s current instance_id configuration.
Syntax
show stp ports <portlist>
Description This command displays the STP Instance Settings and STP Instance
Operational Status currently implemented on the Switch.
Parameters
<portlist> − Specifies a range of ports to be configured. The beginning
and end of the port list range are separated by a dash. For example, 1-4
specifies all of the ports between port 1 and port 4.
Restrictions None
Example usage:
To show STP ports:
77