Chapter 2 Installation DGS-3610 Series H/W Installation Guide
2 Installation
2.1 Prior Preparation
This switch is already prepared for installation at delivery. Before connecting the power
supply and the network, please check all the accessories against the packing list in the
packaging carton.
Read the installation instructions carefully before you power on the
system.
Do not place the switch close to water or in a damp place. Prevent
moisture from entering the switch.
Keep the switch away from the places with much dust or strong
electromagnetic interference.
Attach the four adhesive rubber pads provided in the carton onto the
indentations on the four corners at the bottom of the switch.
Place the switch on the desktop flatly to ensure that the air around the switch
can flow freely.
You can install the handles onto the switch as shown below:
To Next Page
Loading...
Need help?
General