WARNING
• To avoid sickness, flush the coffee system out before operating
it for the first time according to the Flushing Out the Coffee
System section on page 43. Doing so will remove any bacteria left
in the unit during shipping and storage.
• This appliance is equipped with a three-prong grounding plug for
your protection against possible electric shock hazards. Plug it only
into a dedicated, grounded non-GFI electrical outlet.
• Make sure that the coffee system has been properly installed by
a qualified installer according to the accompanying installation
instructions. Have the installer show you the location of the power
connector and the fuse or junction box so that you know where
and how to turn off power to the coffee system.
• Make sure the hardness of the water used in your coffee system
does not exceed the maximum stated below. Using water harder
than that specified will eventually damage the internal parts and
void your warranty.
Before Your Coffee System is Installed
1. Follow the directions on page 5 for testing the water hardness in your house
or building.
2. If you are installing model CM24P-1, contact a water treatment specialist
and have the included flushing system kit installed. See page 5 for details.
3. Have a licensed electrician install a dedicated, grounded electrical outlet
near the coffee system, if one is not available.
4. Have a qualified installer install the coffee system in the desired location
according to the accompanying installation instructions.
After Your Coffee System is Installed
1. Open the milk container compartment and remove the keys. Put them in a
safe place.
2. Gently move the coffee and milk dispenser up or down until it is at the
desired height.
dm ar Automatic Coffee System
To Next Page
Loading...
Need help?
General
