Custom Programming
Your coffee system is programmed at the factory to offer the best performance under most conditions.
However, you can customize how hot drinks are prepared to suit your personal taste. In addition, you can
adjust certain general operation settings (see below).
WARNING
Dacor ® takes no responsibility for any problems caused by changes to the factory default settings.
Changes to the settings may cause severe burns or sickness due to bacteria growth. If your
coffee system fails to operate properly after programming, return the unit to its original factory
programmed settings listed on page 33.
Programmable Features
Button Assignment
(Product Name)
You can change the type of drink prepared when you push a
button. In other words, you can change the button location for a
particular drink.
You can change the amount of water dispensed for each type of
drink.
<_ Amount of Water
(Water Volume)
Grind Time For coffee drinks, you can change the coffee bean grind time to
make the coffee stronger or weaker. The longer the grind time,
the more coffee beans are ground and the stronger the coffee.
Milk Time You can adjust the amount of milk dispensed for a particular
drink by lengthening the milk time.
¢ Pre-brew Pre-brewing soaks the coffee grounds in water to help with
flavor extraction. You can turn it on or off.
Tamping You can turn the tamping feature on or off. Tamping compresses
the ground coffee beans to increase coffee strength.
Used Coffee Ground Bin You can change the amount of coffee that builds up in the used
Meter coffee ground bin before the "Drawer Full" message appears on
the display.
Pre-set at the factory to 2 hours. Do not change.
Pre-set at the factory to 50 cycles. Do not set higher.
Set at the factory. Keep at 2.0.
Set to 250 drinks at the factory. It indicates that the coffee
grinder may need to be adjusted. Do not change this setting
unless coffee quality has changed.
Allows you to set the temperature of the brewed coffee. Dacor ®
recommends you leave it at the factory setting of 208°F.
Allows you to set the temperature of the steamed milk. Dacor ®
recommends you leave it at the factory setting of 257°F.
This feature is for model CM24P-1 only. If a water filter is
installed on the coffee system, you can set the unit to display a
message when the filter needs to be changed.
Milk Cleaning Warning Time
Group Cleaning Warning
Group Setting
Grinder Setting Warning
Coffee Temperature
Steam Temperature
Water Filter
c/acar Automatic Coffee System