Loading Your Coffee System
_--_ WARNING
• To prevent personal injury, keep your hands out of the coffee
bean container and the ground coffee chute.
• Some of the metal surfaces behind the front panel are
hot when the power switch is on. Avoid contact with these
surfaces.
Do not pour flavored, un-roasted, partial coffee beans, or
ground coffee into the coffee bean container. Doing so may
cause the coffee grinding mechanism to jam. Use flavored
coffee creamers or syrups after making the coffee to flavor it.
You may also make flavored coffee using the ground coffee
poured into the (]round coffee chute. See the Decaffeinated
and Ground Coffee section on page 17 for directions.
1. Grasp both sides of the front panel and slide the unit out.
2. On model CH24T-1, pour filtered water (with a water hardness of
4 gpg or less) into the water tank. The tank holds 1 1/4 gallons of
water (5 liters). DO NOT use distilled water.
3. Open the coffee bean container lid. Fill it to 1/2" from the top with,
whole, unflavored, roasted coffee beans. Do not over-fil!!
4. Make sure the water tank, coffee bean container, and ground coffee
chute lids are closed and push the coffee system into the cabinet.
Top of Coffee System
Automatic Coffee System
To Next Page
Loading...
Need help?
General
