Problem Solution Guide (continued)
Display reads: "Please -
Wait Heating".
Display reads: "Drawer
Full" (buttons also don't
work).
Display reads: "Machine
Ready - Drawer Out"
(buttons also don't work).
Display reads: "System
Off- Front Panel Open"
(buttons also don't work).
Display reads: "Please
Milk Clean".
Display reads: "Clean
Group".
Display reads: "Xxxxxx
Group Error" (buttons
also don't work).
Display reads: "Timeout
Filling Up Broiler"
(buttons also don't work).
Display reads: "Flow
Meter Error" (buttons
also don't work).
Display reads: "Error
- Coffee Temperature"
or "Error - Steam
Temperature" (buttons
also don't work).
Display reads: "Too
Much Coffee", Coffee
system ejects the coffee
and does not make
drinks.
The appliance is still
heating up.
The used coffee grounds
bin is full.
The used coffee grounds
bin is not installed
properly.
The front panel door is not
closed.
The cafe latte, latte or
cappuccino button has
been pushed within the last
two hours.
The coffee system needs to
be cleaned.
Operation problem
detected.
Operation problem
detected.
No water in water tank
(Model CM24T-1) or water
supply not connected or
turned on (Model
CM24P-1).
Operation problem
detected.
Too much coffee put in
ground coffee chute.
Grind time programmed
incorrectly.
Wait until display reads "Ready to Operate"
(3-5 minutes).
Empty used coffee grounds drawer (see Group
Cleaning on page 37).
IHPORTANT: The "Drawer Full" message will
not clear unless the drawer is emptied with the
power switch on,
Check to make sure that the used coffee
grounds bin is pushed completely into place
(see Group Cleaning on page 37).
Close the front panel and lock it. Call for
service if message repeats.
Perform a milk cleaning (see page 35). Note:
The coffee system detects when one of the
buttons that dispense milk was last pushed and
displays "Please Milk Clean" two hours later,
even if milk was not actually dispensed. The
message will not clear until a milk cleaning is
performed.
The "Clean Group" message appears every
50 cycles indicating the system is overdue for
a group cleaning (see page 37). The "Clean
Group" message will disappear after the group
cleaning is complete.
Open and close the front panel flap. Call for
service if message repeats.
Turn the power switch off, then on. Call for
service if message repeats.
Pour water in tank (Model CM24T-1) or check
to make sure the water supply is connected
and turned on.
Call for service.
Reduce the amount of coffee you put in the
ground coffee chute.
Change the grind time to the default setting.
See the Original Factory Programmed
d=n ar Automatic Coffee System
To Next Page
Loading...
Need help?
General
