EasyManuals Logo

DAELIM Q2 User Manual

DAELIM Q2
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
39
CAUTION
Turn the ignition switch OFF before
disconnecting the terminal from the battery.
Disconnect the negative(-) terminal lead
from the battery first. When connecting,
connect the positive(+) terminal lead first. If
you work in reverse order, short circuit will
occur resulting in fire.
Make sure that terminals do not contact with
other adjacent parts when handling (+), (-)
terminals. Contact with other parts may
cause spark resulting in electrical equipment
malfunction, fire and electric shock.
Do not apply excessive impact. When
handling the battery, stay away from
flammable materials.
If the electrolyte contact with terminal, it will
be corroded earlier.
The battery is shield type, so do not
disassemble the pouring plug.
When not using vehicle during a long time,
take off the battery from the vehicle to keep
from self-discharge and electric discharge.
Put the battery in a well ventilated place after
charging fully. In case it isn’t available to
take battery off from the vehicle, disconnect
(-) terminal.
STANDARD PLUG : CR8EH-9
If new plug is installed, turn 3/4 and tighten it by using
a plug wrench
If plug is reused, turn 1/8 and tighten it.
When removing the pillion seat and open the battery
cover, you can find the battery.
If the battery terminal(s) is(are) polluted or in-rust,
separate battery and clean it.
Battery terminal in rust with white powder should be
cleaned with warm water.
In case of serious rust of battery terminal, disassemble
the battery cord and grind it with wire brush or
sandpaper.
CLEANING TERMINALS OF BATTERY
B
A
T
T
E
R
Y
B
A
T
T
E
R
Y
BATTERY COVER
BATTERY
Gap
Check and
damager of
washer.
Check crack.
Check gap, pollution
and soot.
WARNING
If plug of different maker or different heat
value is used, it causes unsatisfactory
engine starting, inadequate engine
revolution and output deterioration.
Be sure to use the standard plug(CR8EH-9)
and R(resistance) type plug.
After driving, the spark plug becomes very
hot. When inspecting, pay attention not to
be burnt.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DAELIM Q2 and is the answer not in the manual?

DAELIM Q2 Specifications

General IconGeneral
BrandDAELIM
ModelQ2
CategoryScooter
LanguageEnglish

Related product manuals