DAELIM Q2 User Manual

29
󰿀HEADLIGHT, TAIL LIGHT󰿁
Start the engine and operate switches whether the lights
turn on or not, and simultaneously check whether the
lens of lights being contaminated or not, whether they
are damaged.
󰿀INSPECTION OF WINKER󰿁
Turn a main switch (ON) . By operating winker
switch, check whether the front-rear-left-right lamps
are exactly operated or not, and simultaneously the
operating sound of winker works or not
In addition, check whether lens are dirty or damaged
(cracked) or not.
Turn a main switch (ON) . Check a stop lamp for
proper operation by operating the front wheel and the
rear wheel brakes, and also a lens for damage or
contamination.
●
Be sure to turn a main switch (OFF) prior to
replacing of a bulb.
●
Use only a bulb of rated capacity.
●
After replacement with new bulb, check for proper
operation.
[REPLACEMENT OF HEAD LIGHT
BULBS]
①
Loosen 4 socket bolts and remove the windscreen.
② Untie 7 tapping screws and remove the front cover.
③ Untie 8 tapping screws and 2 bolts and remove
the front under cover.
INSPECTION OF STOP LAMP
BULB REPLACEMENT METHOD
●
SOCKET BOLTS
●
WASHER BOLTS
●
TAPPING SCREWS
BLACK : FRONT ASSEMBLY
RED : REAR ASSEMBLY
LIGHT / WINKER INSPECTION
CAUTION
●
The lighting head light emits very hot
heat. If you touch with naked hand, it
may be burned.
●
When replacing head light lamp, stop
lame and winker lamp, use only a bulb
of rated capacity. Using a lamp
exceeding the rated capacity can cause
over-discharge of battery and wire
burning. It can lead a fire.
●
If the head light is turned off due to
aging while driving at night, it will cause
an accident by obstructing driver’s view.
Check the condition daily.
●
If the tail light is off while driving at
night, it will cause an accident by failure
of notice by the other drivers. Check the
condition daily.
CAUTION
●
Care is to be taken to avoid leaving
fingerprints on a headlight bulb. Failing
to observe this may cause early damage
of the headlight bulb resulted from
concentration of heat.
●
Be sure to wear clean gloves when
replacing a bulb. If touched to it with
bare hands, clean it with a cloth soaked
with alcohol to prevent from early
damage.

DAELIM Q2 Specifications

General

Brand	DAELIM
Model	Q2
Category	Scooter
Language	English