D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
70
Printed in Jan. 2001 PS-MMA0415-E1A
3.3.4. Tappet and cam shaft
z Undercool a new bush with dry ice
for
about 2 hours and press it into position in the
cylinder block using a bench press.
After the pressing operation, measure
the inside diameter of the cam bush to
check if it is not deformed.
z Apply engine oil to the entire face
of the
tappets and slide them into the tappet holes on
the cylinder block.
z Wet the cam bush inside diameter
and
camshaft with oil, and carefully assemble them
while turning the camshaft.
CAUTION :
Be careful not to generate a damage to
camshaft and bush.
z Check to see that the camshaft rotates
smoothly.
To Next Page
Loading...
