D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
71
Printed in Jan. 2001 PS-MMA0415-E1A
3.3.5. Crankshaft
z Install the main bearing (refer to
assemble sequence : right figure)
machined with two holes in the cylinder
block so that the key is aligned with the
key groove, then apply oil to the bearing
surface.
z Heat the crankshaft gear for at least 10
minutes to 120°C, then apply sealant
(Loctite # 641) to the inside wall of the
heated crankshaft gear evenly before
inserting it to the end of crankshaft.
z Semi-tighten a bolt at both sides of the
crankshaft, apply engine oil to journals
and pins, then assemble the crankshaft
with the cylinder block by tightening the
fixing bolts.
CAUTION :
Coat engine oil to the pin and journal of
crankshaft.
z Install the oiled thrust washers
with the
oil groove facing outward.
G1051
To Next Page
Loading...
