D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
72
Printed in Jan. 2001 PS-MMA0415-E1A
z Install the bearing and thrust
washers to
the bearing cap and apply oil to the bearing
and thrust washers.
z Install the bearing cap by matching the
cylinder block No. with the bearing cap
No.
z Apply oil to the entire part of the bearing
cap bolts, then tighten in tightening
sequence to specified torque.
Torque 30 kg.m
z After semi-tightening both bolts
evenly,
tighten them diagonally to the specified torque
using a torque wrench as follows.
<Tightening Order>
(1) First stage : Coat the cap bolts with engine oil
(2) Second stage : Temporary bolt screwing about 1 ～2 threads
(3) Third stage : With impact wrench, tighten up to about 15 kg.m
(4) Fourth stage : With torque wrench, tighten up to about 25 kg.m
(5) Fifth stage : By means of torque wrench, tighten finally in the specified
To Next Page
Loading...
