Daewoo DTD-7500 - Page Handsets; Program a Number into Aphoto Memory; Dialing from a Photo Memory; Base Ringer Tone and Volume Setting

28. PAGE HANDSETS
1. Press the PAGE key to make the
base call your handset.
The base will make a deep loud
sound calling for the handset. Your
handset will start ringing to help you
locate it.
2. Press the key on the handset
or the PAGE key on the base to stop
the paging.
29. PROGRAM A NUMBER INTO A
PHOTO MEMORY
1. While o line, enter the phone
number on the key pad.
2. Press and hold MEMORY for 3
seconds, then press any key (1 to
0) you wish to store the number.
You will hear a “du du” sounds as a
conrmaon.
3. If you wish to replace any
number, repeat steps 1-2.
4. You can customize each buon
with your own picture.
Use our cung guide template to
help you guide cung out pictures.
30. DIALING FROM PHOTO
MEMORY
1. Press MEMORY key and then
press the desired memory number
on the keypad. Then the DTD-7500
will go on-line and dial out within 2
seconds.
2. Press TALK to end the call.
31. BASE RINGER TONE AND
VOLUME SETTING
1. While o-line, press key on
handset and it displays “CALL LOG”.
2. Press or key to scroll to “BS
SETTINGS”.
3. Press key and it displays
“Delete HS”.
4. Press or key and scroll to
”RING SETUP”.
5. Press key and the screen
displays “Melody 1”. Base ringer
should ring. Press or key to
listen to dierent ring melodies (5).
6. Press Vol + or Vol - on base to
adjust ringer volume or to shut it
o.
7. Press key to save the ringer
tone and volume sengs.
Note: While o-line or during an
incoming call, you may also press
either Vol + or Vol - key to adjust
the ringer volume.
32. IN-USE INDICATOR
1. This is a mul-purpose indicator.
If it shows a steady light, that means
you are online and using the phone.
2. It ashes (fast) on an incoming
call.
3. This indicator also ashes when
someone is using an extension
phone on the same line.
33. LINE INDICATOR (OPTIONAL
FEATURE)
1. This indicator is available on some
models and it indicates the status of
the phone line connecon. It should
be normally o.
2. If it shows a steady light, this
indicates the phone line is not
connected, Please verify phone line
connecon, or try a dierent phone
cord / phone jack.
34. REGISTER A NEW HANDSET TO
THE BASE
(Note: Each DTD-7500 is
preregistered in the factory is ready
to use out of the box. You only
38