Daewoo DTD-7500 - Handset De-Register; Register All Handsets; Dialing Mode Setting (Tone or Pulse)

need to do this step if you bought
an extra handset for the system.
A maximum of ve handsets is
allowed)
1. Press PAGE key on the base for
about 6 seconds while oine, the
base starts ashing followed by a
loud beep. This indicates the base
is ready for handset registraon.
(Please complete the following steps
in less than 120 seconds).
2. While o-line, press and hold
the PAGE key on the side of the
handset for about 5 seconds. It will
beep once and the screen displays
“SEARCHING 1”.
3. Wait about 10 seconds for
registraon to take place. A long “du
di du” sound indicates success.
(Note: Aer registering the handset
to base, the antenna symbol will
appear steady on the top le
corner of the LCD. If handset and
base aren’t registered, the antenna
symbol and handset name will be
ashing.)
35. HANDSET DE-REGISTER
Note: This funcon is used when
there is a need to free up a handset
registraon, so a new handset may
be added to the base.
1. Press key while o-line, and
the screen displays “CALL LOG”.
2. Press or key to scroll to “BS
SETTINGS”
3. Press key and the screen
displays “DELETE HS”
4. Press key and it displays PIN?
Then press number keys to input
password to conrm. (factory
default PIN = “0000”)
5. Press key and it displays the
handset for de-register, or press
or to select other handset to de-
register.
6. Press key with a sound of “di
du” meaning successful de-register,
if sounds of “di…”, it means failed
deregister. (Note: The handset on
which this step is being performed
can not be deregistered)
7. Press key to transfer to oine.
36. DE-REGISTER ALL HANDSETS
1. Press PAGE key of base for 5
seconds and the base red light starts
ashing.
2. Press the PAGE key again of base
seven more mes at a normal pace,
the ringer asher indicator should
ash at a faster speed than before
indicang de-register process is in
progress.
3. De-register is complete when the
indicator light goes out followed by
a beep.
4. All previously registered handsets
are now deregistered.
5. You must register the handsets
you want again.
37. DIALING MODE SETTING (TONE
OR PULSE)
(DTD-7500 is factory preset for tone
dialing)
1. While o-line, press key and it
displays “CALL LOG”.
2. Press or key to scroll to “BS
SETTINGS” funcon
3. Press key, then it displays
“DELETE HS”
4. Press or key to scroll to
“DIAL MODE”
5. Press key and it displays
“TONE” or “PULSE”
6. Press or key to select
“TONE” or “PULSE” mode.
39