4-2 Inspection, Maintenance and Adjustment K1000896E Operation and Maintenance Manual
The number is also stamped in the rear frame
on the left side just below the cab (Figure 2).
Engine Serial Number
The engine name plate (identification label) is
attached to rocker cover (Figure 3). The engine
serial number is stamped on the left rear of the
engine block, under exhaust manifold.
SAFETY PRECAUTIONS
1. Before performing any maintenance checks, move pilot cutoff switch to "LOCKED" position. Place a
Warning Tag on controls so that no one begins to operate machine while maintenance checks are
being performed.
2. Clean up all fuel spills. Fuel spills are hazardous, especially around engine.
3. Inspect all fuel lines for leakage. Replace any lines, fittings, O-rings, or filters that show signs of wear
or damage.
4. If a test procedure requires engine to be running, use two people and keep all unnecessary
personnel away from machine.
Figure 2
Figure 3
To Next Page
Loading...
