1-22 Safety K1000896E Operation and Maintenance Manual
BATTERY ELECTROLYTE AND EXPLOSIVE
GASES CAN BE LETHAL
Flush eyes with water for 10-15 minutes if acid is
splashed in face. Anyone who swallows acid
must have immediate medical aid. Call Poison
Control listed in the front cover of the telephone
directory.
Explosive battery gas can be set off by sparks
from incidental contact or static discharge. Turn
"OFF" all switches and engine when working on
batteries. Keep battery terminals tight. Contact
between a loose terminal and post can create
an explosive spark.
DISCONNECT BATTERIES BEFORE ELECTRICAL SERVICE OR ELECTRICAL WELDING
Remove cable to negative terminal first when disconnecting cable. Connect positive terminal cables first
when installing a battery.
USE LOW HEAT PORTABLE LIGHTING
Hot surfaces on trouble lights or portable work lights can set off fuel or battery explosive gases.
MAINTENANCE
USE WARNING TAG DURING SERVICE
Alert others that service or maintenance is
being performed and tag operator's cab controls
– and other machine areas if required – with a
warning notice.
Warning tags for controls are available from
Daewoo distributors; see Figure 20.
DO NOT RUN ENGINE IF REPAIRS OR WORK ARE BEING PERFORMED ALONE
You should always have at least two people working together if engine must be run during service. One
person needs to remain in operator's seat, ready to work controls or stop machine and shut "OFF" engine.
ALWAYS USE ADEQUATE EQUIPMENT SUPPORTS AND BLOCKING
Do not allow weight or equipment loads to remain suspended. Lower everything to ground before leaving
operator's seat. Do not use hollow, cracked or unsteady, wobbling weight supports. Do not work under any
equipment supported solely by a lift jack.
HAOA440L
Figure 19
WARNING
HAOC920L
Figure 20
To Next Page
Loading...
