Local Configurations 119
Figure 5-78
Select the uninitialized device that you want to initialize. Step 3
Click Initialize. Step 4
The Enter Password interface is displayed. See Figure 5-79.
Figure 5-79
Configure the password and email information. Step 5
If you select the Using current device password and email info check box, the
remote device automatically uses the current password and email information, so you
do not need to set the password and email address again and can go to Step 6.
Clear the Using current device password and email info check box. 1)
The password setting interface is displayed. See Figure 5-80.
To Next Page
Loading...
Need help?
General