26
4 System Settings
4.1 Setting Date & Time
You can set time and date for the Signage. Remember to select a correct time zone based on where
the Signage lies.
On the main interface, select Settings > Date & Time.
Set date, time, and time zone. You can also enable the 24-hour format.
The operation takes effect immediately.
Enable IPC time setting, configure the Renewal cycle (24 hours by default), and then click
Save. The time of IPC will be synchronized with that of the Signage within the defined renewal
cycle.
Enable NTP time setting, configure the Renewal cycle, and then click Save. The time of the
Signage will be synchronized with that of the NTP server within the defined renewal cycle.
Date & time
4.2 Selecting Input Source
Input sources include Local (default) and HDMI.
Local: Play projects from your USB drive or through MPS.
HDMI: Play projects from the HDMI input source, for example, your PC.
Different devices support different input sources.
On the main interface, select Settings > Input Source Setting.
Input source
To Next Page
Loading...
Need help?
General
