167
You need to have proper rights to implement the following operations. Please make sure the HDD
has been properly installed.
There are three ways for you to go to record menu.
Right click mouse and then select Manual->Record.
In the main menu, from Setting->Storage->Record.
In live viewing mode, click record button in the front panel or record button in the remote control.
After set schedule record and schedule snapshot function, please enable auto record and auto
snapshot function so that the device can automatically record and snapshot. System supports main
stream and sub stream. There are three statuses: schedule/manual/stop. See Figure 4-37. Please
highlight icon“○” to select corresponding channel.
Manual: The highest priority. After manual setup, all selected channels will begin general recording.
Schedule: Channel records as you have set in recording setup (Main
Menu->Setting->Storage->>Schedule)
Stop: Current channel stops recording.
All: Check All button after the corresponding status to enable/disable all-channel schedule/manual
record or enable/disable all channels to stop record.
Snapshot: Select one or more channel(s) first and then enable/disable schedule snapshot function.
Figure 4-37
4.1.4.6.4 Record Info
After system recorded video files, go to the record info interface to view device name, start time, end time
and etc.
From main menu->Info-System->Record, the interface is shown as below. See Figure 4-38.
To Next Page
Loading...
Need help?
General
