User's Manual
119
4.1.4.3 P2P
Background Information
Scan the QR code on the actual interface to download the cell phone app. Register an account and
then you can use the smart phone to add the device.
Before using the P2P function, make sure that the NVR has connected to the WAN.
4.1.4.3.1 Local Operation
Step 1 Click
Next
button.
The
P2P
interface is displayed. See Figure 4-20.
Select
Main Menu
>
Network
>
P2P
, you can go to
P2P
interface too.
Figure 4-20 P2P
Step 2 Check the box to enable P2P function.
After the P2P function is enabled and connected to the Internet, the system will collect
your information for remote access, and the information includes but not limited to email
address, MAC address, and device serial number.
Step 3 Click
Next
button to complete setup.
The status is online if the P2P registration is successful.
To Next Page
Loading...
Need help?
General
