User's Manual
262
Figure 4-158
Step 3 Select Channel, and then click
Add
.
Step 4 Select the
Enable
check box.
Step 5 Click to draw queuing rule and area.
Step 6 Click under the
Parameters
column, and then select alarm type to
Queue People No.
Alarm
or
Queue Time Alarm
.
Step 7 Click under the
Trigger
column, and configure alarm linkages.
Table 4-49
Parameter Description
Period
Configure the period and in the set time range, the corresponding
configuration item will be linked to start the alarm.
Alarm Out
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the alarm
information to the alarm device.
Latch
When the alarm ends, the alarm extended for a period of time. The time
range is from 0 seconds to 300 seconds.
Alarm Upload
Select the check box. When an alarm occurs, the NVR device uploads an
alarm signal to the network (including the alarm center).
●
This function is for some series products only.
●
You need to set the alarm center first. For details, see "4.11.14 Alarm
Center".
Send Email
Select the check box. When an alarm occurs, the NVR device sends an
email to the set mailbox to notify the user.
You need to set the email first. For details, see "4.11.11 Email".
To Next Page
Loading...
Need help?
General
