181
4.6.7 Built-in Switch Setup
The built-in switch function is for product of PoE port.
From Main menu->Setting->Network->Switch, you can set switch IP address, subnet mask, gateway and
etc. See Figure 4-31.
Figure 4-31
4.7 Preview
After device booted up, the system is in multiple-channel display mode. See Figure 4-32.Please note the
displayed window amount may vary. The following figure is for reference only. Please refer to chapter 1.3
Specifications for the window-amount your product supported.
Figure 4-32
4.7.1 Preview
To Next Page
Loading...
