Interface Operation 63
Figure 6-23
6.3.3 VTH Config
Configure VTH info.
VTH “Room No.” shall be the same with “VTH Short No.”, which is set at VTO WEB interface or
Express/DSS platform server.
Press [Setting] for over 6 seconds.
The system pops up “Password” prompt box.
Enter the password set during initialization, and press [OK].
Press [VTH Config].
The system displays “VTH Config” interface, as shown in Figure 6-24.
Figure 6-24
Set VTH info.
Be used as a master VTH.
Enter “Room No.” (such as 9901 or 101#0).
“Room no.” shall be the same with “VTH Short No.”, which is set when adding
VTH at WEB interface. Otherwise, it will fail to connect VTO.
In case of extension VTH, room no. shall end with #0. Otherwise, it will fail to
connect VTO.
Be used as an extension VTH.
Press [Master] and switch to “Extension”.
Enter “Room No.” (such as 101#1) and “Master IP” (IP address of master VTH).
To Next Page
Loading...
Need help?
General
