Device Debugging 28
Figure 5-13
Enter “Password”, “Confirm Pwd” and “Email”. Step 2
Press [OK]. Step 3
The system displays main interface, as shown in Figure 5-14.
Figure 5-14
5.1.2.2 Set Device Network
According to available network connection modes, configure VTH network information.
IP addresses of VTH and VTO shall be in the same network segment. Otherwise, VTH will fail
to obtain VTO info after configuration.
Press [Setting] for more than 6 seconds. Step 1
The system pops up “Password” prompt box.
Enter the password set during initialization, and press [OK]. Step 2
Press [Network]. Step 3
To Next Page
Loading...
Need help?
General
