Daikin BRC2E61 - Dry Operation

24
10.2 Dry operation
Preparation
• Formechanicalprotectionpurpose,turnonthepowertotheairconditioneratleast6hoursbefore
starting the operation.
• Drymodemaynottobeselected,iftheremotecontrollerhasnoeligibilitytoselectCooling/Heating
mode (Refer to page 26 for details).
Operation
1
• Press the Mode Selector button ( ) several
times until Dry mode is selected.

Dry mode may not be available depending on
the type of indoor unit.
2
• PressON/OFFbutton( ).
Theoperationlamp(green)willbelitandtheair
conditionerwillstartoperating.

The air conditioner controls temperature and
airowrateautomatically.Therefore,the
temperatureorairowratesettingsarenot
availablewhiletheairconditionerisin
operation.
3
• WhenON/OFFbutton( )ispressedagain,the
airconditionerwillstopoperatingandthe
operationlampwillbeturnedoff.
Note:
• Topreventwaterleakageorsystemfailure,donotturnoffthe
powerimmediately.Waitatleast5minutesforthedrainpumpto
nishdrainingresidualwaterfromtheindoorunit.
01_EN_4P543053-1C.indd 24 10-May-19 4:13:28 PM