Daikin DAR09 - Page 11

11
PRODUCT IDENTIFICATION
DX13SN*
Model/Rev Description
DX13SN0[18-36]1AA
Introduction of Daikin 1.5 ton 13 SEER R-410A Condensers conversion to 23" chassis for
the 1.5 - 3 ton models.
DX13SN0[42-60]1
Changed from current four piece louver assembly to a two-piece louver plus a corner post
on 26" and 29" chassis.
DX13SN0611AA
Introduction of Daikin 13 SEER R-410A Condensers that supplement our current 5 ton
models.
DX13SN0[18-61]1AB
One hairpin removed (one hole at the top of the coil and one hole at the bottom of the coil
will remain open). No change in coil circuits.
DX13SN0[18-24]1AC Refrigerant quantity reduction.
DX13SN0[18-24]1BA Initial release of Daikin Base Tier 1.5T and 2.0T models.
DX13SN0241BA
Convert ANX13 / 14 1.5 and 2 ton models to Rechi compressors.
These will be a copy of GSX Rechi models.
DX13SN0[30-60]1AC Refrigerant charge reduction.
DX13SN0241BB
DX13SN0301AD
Create new Motor & Replace 0131M00294 with 0131M00800
DX13SN0611AC Create new Motor 0131M00807 & Replace 0131M00061 with 0131M00807
DX13SN0[18,36,42,48,60]1AD
DX13SN0241BC
DX13SN0301AE
Factory Refrigerant Charge Optimization
DX13SN0181BA
DX13SN0181BB
Replaced 50N382XV-ZAKM Rechi compressor with rechi 50N382YV-ZAKM compressor
in all models.
DX13SN0181AE Replaced motor 0131M000266 with 0131M00811
DX13SN0[36,42,48,60]1AE Replaced motor 0131M00018P with 0131M00813
DX13SN0421AF
DX13SN0421AG
Change from copper wound compressor motor to aluminum wound compressor motor.
ZP34K5EPFV130 and ZP36K5EPFV130.
DX13SN
Daikin® BRAND X-R410A 13 SEER SINGLE STAGE NO MINAL CONDENSERS